Updated Using the software (markdown)

Using-the-software.md

@@ -1,7 +1,7 @@
 # Menu entries
 In order to get into menu hold MODE button.\
 Below we put all available entries that are available to change with a short explanation.
-##Page 1
+## Page 1
 - **Volume** - audio output level
 - **Converter Offset** - local oscillator frequency of any used converter)
 - **Low band edge** - lowest frequency that you can tune into
@@ -12,7 +12,7 @@ Below we put all available entries that are available to change with a short exp
 - **High Cut threshold** - belongs to the previous option, this is the signal value below which the previous option must become active
 - **Low Level threshold** - if signals become very weak, data crosstalk of the entire circuit can become audible in the sound. With this option you can delay the data stream for low signal strengths, ideal for DX
 - **Display brightness** - TFT contrast
-##Page 2
+## Page 2
 - **Language** - choose UI language
 - **Show RDS errors** -
 - **Softmute FM** -
@@ -23,18 +23,18 @@ Below we put all available entries that are available to change with a short exp
 - **USB mode** -
 - **Wi-Fi active** -
 - **Configure Wi-Fi** -
-##Page 3
+## Page 3
 - **Stationlist client IP** -
 - **Show SW wavelength** -
 - **RDS filter** -
 - **Show PI errors** -
-- *Show squelch** -
+- **Show squelch** -
 - **Modulation meter** -
 - **AM Noise blanker** -
 - **FM Noise blanker** -
 - **Audio output** -
 - **FM OIRT 30 kHz steps** -
-##Page 4
+## Page 4
 - **Theme** -
 - **About software** -
 - **Power options** -